Autel KM100 Read PIN Code & Add 2022 Hyundai i10 ID4A Successful : AutelShopDE Official Online Store > 자유게시판

Autel MaxiIM KM100 IMMO Key Programmer can support 2022 Hyundai Grand i10 pin code reading and ID4A key adding, also supports all key lost & remote learning. Check below for more details:

Autel KM100 Coverage : Hyundai (EU)

Vehicle Model Year System Add Key All Keys Lost Read Password Remote Learning IMMO Parts Replacement I10(IA) 2014-2016 Immobilizer By OBD By OBD By OBD By OBD ECM, Smartra I10(IA) 2014-2016 Keyless System By OBD By OBD By OBD × ECM, SMK, ESCL I10(IA) 2017- Immobilizer By OBD By OBD By OBD By OBD ECM, Smartra I10(IA) 2017- Keyless System By OBD By OBD By OBD × ECM, SMK, ESCL I10(PA) 2008-2010 Immobilizer (Other) By OBD By OBD By OBD By OBD ECM, Smartra I10(PA) 2008-2010 Immobilizer (TCI-U) OBD OBD OBD OBD OBD ECM, Smartra I10(PA) 2011-2017 Immobilizer OBD OBD OBD OBD × ECM, Smartra

Autel KM100 Program 2022 Hyundai Grand i10 Key

1. Generate Key

Insert Autel IKEY Smart Key into KM100 slot.

Universal Key >> Hyundai Grand i10(AI3) 2020-2022 >> Generate Universal Key

Completed.

2. Read Pin Code

IMMO >> Hyundai >> Manual Selection >> Europe >> I10(AC3) >> 2020- >> Smart Key >> Yes >> Immo Status Scan >> Read PIN >> Read Pin Code (4A Smart Card)

This function only supports models with 4A chip type smart card. Please make sure the key type is correct. Press "Yes".

Press the START button to turn on the hazard warning lights.

Password to be read: 439476

3. Add Key

Add Key >> Start

This function supports adding keys and losing all keys.

When you run this function, all existing keys will be erased. You need to re-learn all old keys to be able to use it normally. Press "Yes" to continue.

Turn off the ignition.

(Note: the instrument screen is black.)

Open and close the driver's door once!

Please enter 6-digit security code: 439476

OK >> Yes

Within 5 seconds of pressing OK, use the back or top of the smart key to press and hold the START button for 5 seconds until the anti-theft light flashes.

(If the operation fails at the prompt, remove the key case and re-run the steps above to ensure the key chip is successfully programmed.)

Programming successful.

Press "Yes" to program the next program, press "No" to complete.

Test the key. It works fine.

Success!